CM5532194900Z - Zinc Anode - for salt water use. Not recommended for fresh water.
Mounts on bottom of stern bracket.
Fits the following Suzuki outboards:
DF60 - DF300 2001 and later
DT115 - DT140 1996-2001
Dimensions:
...

CM589150Z - Zinc Anode - for salt water use. Not recommended for fresh water.
For Lewmar thrusters with a 140mm tunnel diameter.
Dimensions:
Length: 15.24mm (0.600in)
Width: 38.10mm (1.500in)
Depth: 15.24mm (0.600in)
...

CMVM40PZ - Zinc Anode - for salt water use. Not recommended for fresh water.
Dimensions:
Length: 39.88mm (1.570in)
Width: 13.97mm (0.550in)
Depth: 0.00mm (0.000in)
Categories: Inboard / Jet Anodes, Engine Cooling System...

CM327606Z - Zinc Anode - for salt water use. Not recommended for fresh water.
Fits Johnson 2 - 150HP Outboards
Dimensions:
Length: 60.96mm (2.400in)
Width: 22.86mm (0.900in)
Depth: 12.70mm (0.500in)
Categories: Outboard...

CM806189M - Magnesium Anode - for fresh water only. Not recommended for salt or brackish water. 
Lift-Trim Cylinder Ram End Horseshoe Anode for Mercury Outboard & Mercruiser Sterndrive and engines , Fits: Alpha 1 Gen 2 ,Mercury part:...

CM806190M - Magnesium Anode - for fresh water only. Not recommended for salt or brackish water. 
Lift-Trim Cylinder Ram End Horseshoe Anode for Mercury Outboard & Mercruiser Sterndrive and engines, Fits: Bravo 1, 2, 3 and Blackhawk drives,...

CMM3060KITA - Aluminium Anode - for use in salt and brackish water.
Fits F30-F40-F60 Honda Outboard Motors
This kit contains:
• CM17264C1 X 1
• CM826134 X 2
• CM818298 X 1
Dimensions:
Length: 203.20mm (8....

CMSGHA650A - Aluminium Anode - for use in salt and brackish water.

Used on HJ274, HJ292, HJ362, HM422 and other Hamilton jet drives.

CMX00 - Zinc Anode - for salt water use. Not recommended for fresh water.
• Interlocking halves
• Full shaft contact (100% circular radius)
• Extra alloy around the fastener
• Easy installation underwater
• Bolt retaining...

CMPNZA - Zinc Anode - for salt water use. Not recommended for fresh water.
• Fasteners are included with all replacement prop nuts.
• Nylon patch is good for one initial application only.
• Please use lock tite or teflon tape to...